We strive to supply all of our customers with the quality that they deserve and the craftsmanship they expect. The following are specifications and answers to some of the most commonly asked questions regarding repipes.

MATERIAL

• AquaTek installs only the finest quality materials in your home. Our piping is type (L), copper - commercial grade. Although there are thinner and thicker grades of pipe available, it is our professional opinion that this is the best pipe for your home. Also included are Pex piping (polyethylene cross-link tubing), PVC, CPVC, and any other pre-approved materials specified in our original estimate.

• All fittings will be made of wrought, copper or rough brass.

• Where gate valve shut offs are being used, i.e. water heater, water main, water softener, irrigation isolation valves, ball valves will be installed in their place. They operate on a quarter turn. Due to the fact that they are made of brass and stainless steel, they will give you many years of operation.

• The solder we use to sweat the copper pipe together is lead-free and comprised of 95% tin and 5% alloys.

ACCESS TO PIPING

AquaTek employs its own sheetrock and stucco repair crew. Unless otherwise noted on your written estimate, we will cut all walls where needed to access areas of piping, i.e. under cabinets, rear of toilets, rear of water heaters, shower valves. After pipe installation and inspection by city inspector, the sheetrock and stucco will be replaced to a textured surface, unless texture is painting process. Painting and wallpaper repairs to be performed by others.

PIPING SYSTEM

• Unless otherwise noted on estimate sheet, all domestic piping will be replaced from where water main enters the home to all fixtures. Where Smitty remodeling plates are used on showers & tub/showers, existing risers will be reused to eliminate wall and tile damage. All warranties apply. We suggest that the water main be replaced from the meter to the house. If it is of galvanized steel, AquaTek will dig and back fill to a finished grade. Shrubbery is excluded unless otherwise noted on the estimate. We suggest either sch 40 PVC plastic, or type (L) copper water main. In both cases, a long life is guaranteed.

• All manifold piping below floor is suspended by Teflon straps, copper straps, and Teflon coated hangers. As piping penetrates floor plates, this is known as raisers. They will be replaced in the same manner. NOTE: pipe to wood contact, in AquaTek’s view is considered to be less than good craftsmanship. Due to expansion and contraction of pipe, if it comes into contact with the wood, the new piping system will be noisy, and often squeak. For this reason, the raisers and manifold will be suspended from the structure.

• Angle stops, which are shut offs for each fixture, will be placed with Brasscraft units. All supply tubes that hook up to fixtures from the angle stops will be replaced with braided stainless steel. The existing fixtures and flex lines are not replaced unless noted on the estimate.

PERMITS

Because of the fact that your entire home is being repiped, it is not considered to be a “repair”, therefore, the city or county that you reside in will require that a permit be issued. A representative of AquaTek will stand the inspection when the piping has been completed. Permits are to be charged as extra (in addition to the contract total) – actual cost plus a $140.00 administrative fee to acquire the permit (waiting time, etc.). However, the property owner reserves the right to acquire his/her own permit and list AquaTek Plumbing, Inc. as the contractor on the permit application in order to eliminate this cost.

ACCESS

As a licensed and bonded company, AquaTek Plumbing, Inc. does not require the homeowner to be home during the entire course of the repipe. Access in and out of the home is all that is necessary.

HOT WATER RECIRCULATION

Hot water recirculation systems are available from AquaTek. These systems are an outstanding emenity to the home in that they supply hot water instantly throughout the home. In our systems, we utilize the Grunfos 1518-SU pump and timer, attached to a fully insulated water and recirculation pipe manifold. NOTE: if there is not an electrical plug within 3 feet of the recirculation pump, one will need to be installed by an electrician at the home owner’s expense. This unit can be turned on and off by setting the timer to the style of your living conditions.

WARRANTY

The warranty begins on the date of final payment of the contract. AquaTek Plumbing, Inc. warrants against installation and manufacturer defects for (25) years on all copper water piping that we supply and install. A one-year warranty is given on all valves, pumps and fixtures that we supply – materials and workmanship included.

Warranty is valid provided that failure occurs within (25) years from the date the warranty begins and the Homeowner or homeowner representative promptly notifies AquaTek Plumbing, Inc. of failure in writing; mail to: P.O. Box 23271, San Jose, CA 95153, via email to info@aquatekplumbing.com, fax to 408-295-7787 or by calling 408-295-7767. AquaTek Plumbing, Inc. will correct that failure by repairing or replacing the Product within a reasonable amount of time, without charge; the decision for repair or replacement shall be that of AquaTek Plumbing, Inc.

We do NOT warrant against failure:

1. for fixtures that were present at the time of the project and/or that we did not supply and install;
2. caused by, contributed in whole or in part by, or resulting from natural disasters, such as, without limitation, flooding, earthquake, windstorm and lightening;